Transmission Housing And Gear Shift Unit

WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Transmission Housing And Gear Shift Unit

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Bolt, 25 Nm
Flange Shaft with Pressure Spring
- Removing and installing, refer to one of the following:
  LEFT FLANGE SHAFT AND SEAL .
  
  RIGHT FLANGE SHAFT, SEAL WITH SLEEVE (ONE-PIECE) .
  
  RIGHT FLANGE SHAFT, SEAL AND SLEEVE (TWO-PIECE) .
- Assembling, refer to DIFFERENTIAL .
TORX® Bolt
- 25 Nm
- Always replace.
- Self-locking.
- For the reverse shaft support.
TORX® Bolt
- 30 Nm
- Always replace.
- Self-locking.
- For the reverse shaft support.
O-ring
- Always replace.
Support Pin
Bolt
- 25 Nm
Bolt
- 25 Nm
Sealing Cap
Bolt
- 25 Nm
- Always replace.
- For the reverse shaft support.
Bolt
- 5 Nm
Transmission Neutral Position Sensor -G701-
- Not available in the US/Canadian market.
- For vehicles with the Start/Stop System.
Transmission Housing
- Remove together with 5th gear. Refer to TRANSMISSION .
- Disassembly and assembly, refer to TRANSMISSION AND CLUTCH HOUSINGS .
Clutch Housing
- Disassembly and assembly, refer to TRANSMISSION AND CLUTCH HOUSINGS .
Bolt
- 25 Nm + 90° (1/4) additional turn.
- Always replace.
Gear Shift Unit
- Disassembly and assembly, refer to GEAR SHIFT UNIT .
Bolt
- 25 Nm