Transmission Housing And Shift Mechanism
WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 25 Nm
- Flange Shaft with Pressure Spring
- Removing and installing, refer to one of the following:
- Assembling, refer to DIFFERENTIAL .
- Bolt
- 25 Nm
- For the reverse shaft support.
- Self locking.
- Always replace.
- Bolt
- 30 Nm
- For the reverse shaft support.
- Self locking
- Always replace.
- O-ring
- Always replace
- Pivot Pin
- Bolt
- 25 Nm
- Bolt
- 25 Nm
- Sealing Cap
- Bolt
- 25 Nm
- For the reverse shaft support.
- Always replace.
- Bolt
- 5 Nm
- Transmission Neutral Position Sensor -G701-
- For vehicles with the start/stop system.
- Transmission Housing
- Remove together with 5th gear, refer to TRANSMISSION .
- Disassembling and assembling, refer to TRANSMISSION HOUSING AND CLUTCH HOUSING .
- Clutch Housing
- Disassembling and assembling, refer to TRANSMISSION HOUSING AND CLUTCH HOUSING .
- Bolt
- 25 Nm + 90° (1/4) additional turn.
- Always replace.
- Selector Lever with Selector Cover
- (Shift unit)
- Disassembling and Assembling, refer to SHIFT UNIT .
- Bolt
- 25 Nm