Input Shaft, Output Shafts, Differential And Shift Forks
WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Input Shaft, Output Shaft (Pinion Shaft), Differential And Shift Forks, Removing And Installing, Overview
- Differential
- Disassembling and assembling, refer to DIFFERENTIAL .
- Seal
- Quantity: 4
- Always replace.
- Output Shaft
- Disassembling and assembling, refer to OUTPUT SHAFT .
- Reverse Gear Shaft Support
- Disassembling and assembling, refer to REVERSE SHAFT .
- Reverse Shaft
- Disassembling and assembling, refer to REVERSE SHAFT .
- Input Shaft
- Disassembling and assembling, refer to INPUT SHAFT .
- Reverse Gear Selector Fork
- Disassembling and assembling, refer to SHIFT FORKS .
- Installed position, refer to TRANSMISSION .
- Bolt
- 25 Nm
- Selector Fork with Rail
- (Shift forks)
- Disassembling and assembling, refer to SHIFT FORKS .
- Clutch Housing
- Disassembling and assembling, refer to TRANSMISSION HOUSING AND CLUTCH HOUSING .
- Nut
- 25 Nm + 90° (1/4) additional turn.
- 4 nuts for the bearing mount.
- Always replace.
- Flange Shaft with Pressure Spring
- Removing and installing, refer to one of the following:
- Assembling, refer to DIFFERENTIAL .
- Bolt
- 25 Nm