Coolant Hose Connection Diagram
WARNING: This page is about a different car, the 2009 Volkswagen Rabbit, 2008 Volkswagen Rabbit, 2007 Volkswagen Rabbit, and 2006 Volkswagen Rabbit. However, it is still accessible from the selected car via links, so may be relevant.
- Radiator
- Removing and installing, refer to RADIATOR .
- Replace the coolant after replacing.
- Coolant Pipe
- Intake Manifold
- Coolant Pump and Coolant Thermostat
- Coolant pump removing and installing. Refer to COOLANT PUMP .
- Thermostat removing and installing. Refer to COOLANT THERMOSTAT .
- Checking the coolant thermostat, see -item 17- in Part 1 of the COOLANT PUMP AND THERMOSTAT OVERVIEW .
- Front Coolant Pipe
- Secured to the accessory bracket.
- Right Coolant Pipe
- Secured to the engine mount.
- Expansion Tank
- With a cap.
- Checking the pressure relief valve in the cap. Refer to CHECKING THE PRESSURE RELIEF VALVE IN THE CAP .
- Rear Coolant Pipe
- Cylinder Head/Cylinder Block
- Replace the coolant after replacing.
- Coolant Flange
- Quick-Release Coupling
- Lower connection.
- Heater Core
- Replace the coolant after replacing.
- Quick-Release Coupling
- Upper connection.
- Bypass Thermostat
- Only for vehicles with a automatic transmission.
- Overview, refer to Figure.
- Checking, refer to CHECKING THE BYPASS THERMOSTAT .
- Automatic Transmission Fluid Cooler
- Only for vehicles with a automatic transmission.
- Engine Oil Cooler
- Coolant Hose
2 versions:
- Without a engine pre-warmer
- With a engine pre-warmer
- Pre-Warmer
- Only on vehicles with a engine pre-warmer.
- Throttle Valve Control Module -J338-
- Connection only for a coolant heated throttle valve control module.
- Coolant Hoses
- Only for a throttle valve control module heated by coolant.
- Quick-Release Coupling
- Upper connection.
- Quick-Release Coupling
- Lower connection.