Seal, Between Transmission And Bevel Box, Transmission Side

WARNING: This page is about a different car, the 2008 Volkswagen R32. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Pulling hook T20143
Used oil collection and extraction device VAG 1782
Thrust piece T10243

Procedure

-- Remove the bevel box. Refer to BEVEL BOX .

Place the VAG 1782 beneath the transmission.

-- Pry out the seal on the transmission using the T20143/1 or the T20143/2.

-- Fill the space between the sealing lip and dust lip -arrow- halfway with sealing grease G 052 128 A1.

Fig 1: Identifying Oil Seals Sealing Lips

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Lightly lubricate the seal with oil on the outer circumference.

-- Carefully install the seal until seated using the T10243.

Fig 2: Identifying Sealing Ring Carefully Driven In As Far As Stop Using Thrust Piece T10243

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the bevel box. Refer to BEVEL BOX .

-- Check the transmission fluid level and fill if necessary. Refer to OIL FILTER, CHANGING AND OIL LEVEL, ADJUSTING .