Seal, Between Bevel Box And Transmission, Bevel Box Side

WARNING: This page is about a different car, the 2008 Volkswagen R32. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Pulling hook T20143
Thrust piece T10298

Procedure

-- Remove the bevel box. Refer to BEVEL BOX .

-- Pry out the seal on the bevel box using the T20143/1 or the T20143/2.

Fig 1: Identifying Pulling Hook T20143/1 Or T20143/2 To Pry Out Sealing Ring On Bevel Box

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Fill the space between the sealing lip and dust lip -arrow- halfway with sealing grease G 052 128 A1.

Fig 2: Identifying Oil Seals Sealing Lips

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Lightly lubricate the seal with oil on the outer circumference.

-- Install the seal until seated using the T10298.

Fig 3: Identifying Sealing Ring Driven In As Far As Stop Using Thrust Piece T10298

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.