Slave Cylinder: Installing

Install in reverse order of removal.

-- Install the clutch slave cylinder and tighten the bolts -arrows B- to specifications.

Fig 1: Identifying Transmission Support And Slave Cylinder

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Attach the hose/line assembly to the clutch slave cylinder.

-- Push the hose/line assembly clamp all the way in.

-- Pull on the hose/line assembly to make sure it is secure.

-- Install the transmission support and bolts -arrows A-.

-- Bleed the clutch system after installing the clutch slave cylinder. Refer to CLUTCH SYSTEM, BLEEDING .

Assemble the selector mechanism. Refer to SHIFT AND SELECTOR CABLES .

Adjust the shift mechanism. Refer to SHIFT MECHANISM, ADJUSTING .

-- If removed, install the air filter housing. Refer to one of the following:

Diesel engines, refer to [For engine(s) BRM] Description and Operation .

Gas engines, refer to [For engine(s) BGP, BGQ, CBTA, CBUA] Description and Operation .

-- Connect the ground cable to the battery. Refer to Removal and Installation .