Battery, reconnecting
WARNING: This page is about a different variant/trim than selected.
Special tools and auxiliary items needed
- VAG 1331 Torque wrench (or equivalent 5 - 50 Nm )
NOTE:
- In order to prevent damage to the battery housing, battery terminals must be placed on battery posts without using force (by hand only).
- Battery posts and terminals must no longer be greased.
- Refit battery positive ( B+ ) terminal on battery positive post.
- Torque positive ( B+ ) terminal clamp fastener to 6 Nm.
- Release elastic cord from fuse holder and slide into mounting.
- Clip fuse holder mountings into battery box -1 and -2-.
- Only after the fuse holder and positive ( B+ ) terminal have been secured should the negative ( - ) terminal clamp be installed.
- Torque negative ( - ) terminal clamp fastener to 6 Nm.
- If necessary, reinstall cover -1- with screws -arrows-.
- Reinstall and secure battery cover.
- Clip positive cable into retainer.
- Perform work steps specified in table. Refer to Work steps required after reconnecting battery .