LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2005 >> Jetta TDI, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Electrical Equipment (A4 Platform)) >> 27 Battery, Starter, Generator, Cruise control >> Battery, disconnecting and reconnecting >> Battery with clipped fuse holder, disconnecting and reconnecting >> Work steps required after reconnecting battery

Work steps required after reconnecting battery

WARNING: This page is about a different variant/trim than selected.
Work steps  completed? 
Ignition:
Switch ignition on and then off again.
 
Diagnostic Trouble Code (DTC) Memory:
Check using VAS 5051 Tester in mode "Guided Fault Finding".
 
Power windows (where applicable):
Completely open and close all power windows.
 
Radio:
Input anti-theft radio code and check radio, CD & tape player functions as applicable.
 
Clock:
Check and reset to local time.
 
All electrical consumers:
Check function.
 
NOTE: If desired, print this information and use the table above as a checklist.