Rear lid lock, removing and installing (Jetta)

1 - Lock cylinder housing 

• Removing and installing. Refer to Lock cylinder housing, removing and installing 

2 - Handle 

• Removing. Refer to 70 - INTERIOR TRIM

• Remove bolt , disconnect connector for switch and remove handle from lid.

3 - Switch for rear lid release E165  

4 - Rear Lid 

5 - Lock 

• Removing. Refer to 70 - INTERIOR TRIM

• Disconnect connector from lock.

6 - Hex nut 

• 7 Nm

7 - Actuator lever with linkage clip 

8 - Motor for rear lid release V139  

• Removing. Refer to 70 - INTERIOR TRIM

• Disconnect connector from motor.
• Remove nuts and remove carrier plate.
• Remove motor for rear lid release from carrier plate.

9 - Actuator lever 

10 - Hex nut 

• 7 Nm

11 - Actuator rod  

12 - Support bracket  

13 - Actuator rod 

14 - Bolt 

• 7 Nm