Headlamp washer jet retainer, removing and installing

Fig 1: Cover Cap And Bearings On Spray Jet Holder

GW00012069

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing:

CAUTION:

Switch off all electrical consumers.
Switch ignition off and remove ignition key.

Remove washer jet with cover - 1 - up to stop out of bumper cover.
Unclip cover - 1 - from retainer - arrows -.

Fig 2: Lifting Lug And Pulling Out Spray Jet Holder

GW00012071

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Lift lug - arrow - slightly and pull out washer jet holder.

Installing:

NOTE:

With the lugs on the washer jet holder, it can be adjusted how strongly the washer jet cover is fastened onto bumper cover. If washer jet holder is not slid in far enough, cover does not close. If washer jet holder is slid in too forcefully, cover and bumper cover may be deformed.

Slide washer jet holder into telescoping cylinder until it engages.
Install cover onto washer jet holder and let down telescoping cylinder.
Check cover for correct seating on bumper cover.
Adjust cover if necessary by shifting washer jet holder into a higher or lower catch on the telescoping cylinder.

Bleed headlamp washer system after completing assembly work → Headlamp washer system, bleeding .
Check washer jets for headlamp washer system and adjust if necessary → Headlamp washer system spray jets, checking and adjusting .