Only Vehicles Through 05.05

NOTE:

Both lifting eyes for the engine support bridge are located on the cylinder head, for that reason an additional holder to support the engine must be secured on cylinder block.

-- Fasten the engine support T10014 into the threaded bore above the coolant pump to 20 Nm.

Fig 1: Identifying Engine Support Bridge 10-222 A And Support T10014

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Using spindle -A-, lift engine slightly until spindle -B- is unloaded.

-- Unhook the spindle -B- and push it aside.

Continuation for All

-- Remove cylinder head cover CYLINDER HEAD COVER .

-- Follow the sequence when loosening the cylinder head bolts.

Fig 2: Identifying Cylinder Head Bolts Loosening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Lift the cylinder head slightly and then remove it from the engine sideways, past the toothed belt guard.

NOTE:

The cylinder head must be carefully guided to prevent damages.