Data Bus On Board Diagnostic Interface J533, emoving and installing
NOTE:
- Before removing Data Bus On Board Diagnostic Interface J533, he work procedure to read out the coding stored in the module must always be performed → Instrument cluster, replacing .
Removing:
CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Remove drivers footwell cover → 68 INTERIOR EQUIPMENT .
Fig 1: Disengaging Harness Connector And Disconnecting It From Data Bus On Board Diagnostic Interface J533
- Disengage electrical connection lock - 1 - and disconnect from Data Bus On Board Diagnostic Interface J533 - 2 -.
- Press mounting pins - 3 - together - arrows - and out of holes.
Installing:
Install in reverse order of removal.