Instrument cluster, removing and installing
NOTE:
- Before removing instrument cluster, perform work procedure "Replacing instrument cluster" in order to read data stored in control module → Instrument cluster, replacing .
Removing:
NOTE:
- It is not necessary to remove the steering wheel or upper steering column trim in order to remove the instrument cluster. For clarity, steering wheel and trim are shown removed in Fig 1 .
CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Disconnect gap cover from instrument cluster and place on steering column → 68 INTERIOR EQUIPMENT .
NOTE:
- The gap cover "snaps out" to allow removal of instrument cluster without removing the steering column trim.
- Remove screws - arrows -.
NOTE:
- The fixed electrical connection to the instrument cluster is disconnected automatically when the cluster is pulled out of the instrument panel opening.
- Pull instrument cluster out of instrument panel.
Installing:
Install in reverse order of removal.