Wiring harnesses and connectors, general repair measures
CAUTION:
- Note CAN-Bus wiring repair measures → CAN-Bus wiring, repair measures .
- Soldering is not permitted!
- Do not repair welded connections in the wiring harness. Fabricate and connect an appropriate overlay harness instead.
- Wiring harness and connector repairs must only be performed using VAS 1978 Wiring Harness Repair Kit VAS 1978 Instruction Manual.
- Only the yellow repair cables and insulation tape supplied with VAS 1978 are to be used for wiring/connector repairs. The use of yellow repair wires and yellow insulation tape identifies that a repair has taken place VAS 1978 Instruction Manual.
- All shielded wiring (E.g.: knock sensors, antenna etc.) are Not to be repaired! Replace complete wiring harnesses as necessary.