CAN-Bus wiring, repair measures
- CAN-Bus wiring consists of unshielded, two-cable wiring - 1 - and - 2 - with a cross-section of 0.35 mm 2 or 0.5 mm 2 .
- Color coding:
| CAN-High-wire, powertrain | orange/black |
| CAN-High-wire, Comfort | orange/green |
| CAN-High-wire, Infotainment | orange/violet |
| CAN-Low-wire (all) | orange/brown |
CAUTION:
- Perform wiring harness repairs only with yellow wires from VAS 1978 Wiring Harness Repair Kit. Mark repair locations with yellow tape.
- Both bus wires must be the same length. When both wires - 1 - and - 2 - are twisted, length A = 20 mm must be maintained for the twist.
- No part of the bus wiring in the vicinity of heat-shrink sleeves - arrow -, ay be greater than B = 50 mm without the wires being twisted.