Determining shim -A- thickness

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2007 Volkswagen Golf, 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, and 2004 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Measuring Gaps To Determine Shim Thickness

Courtesy of VOLKSWAGEN UNITED STATES, INC.

For the measuring sequence the transmission housing must be clamped into the assembly stand so that the input gear is facing downward, as illustrated on. Refer to Overview of components to adjust reverse gear brake -B1- .

Shim thickness is determined by gap "x" and selected from table. Refer to Table of shims .

x = k + l/2 - m

A = Shim
x = Gap
I = Position of piston in freewheel
m = Height of plate set including pressure plate

K = Constant = 26.9 mm

"K" is determined by installed height in transmission housing and is not adjustable.

Calculating "I":

Fig 2: Identifying Straightedge On Outer Race Of Freewheel & Depth Gauge On Inner Edge Of Piston

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Press piston in direction of arrow up to stop.
Place straightedge "A" onto outer race of freewheel.
Measure to inner edge of piston with depth gauge "B"

Example:

Reading	=	51.8 mm
- Straightedge	=	- 48.2 mm
Calculated size l	=	3.6 mm

Calculating "m":

Fig 3: Identifying Straightedge On Thrust Plate & Depth Gauge On Plate Set

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Place straightedge "A" on thrust plate.
Compress set of plates including pressure plate in direction of arrow and measure thickness of plate set with depth gauge "B".

Example:

Reading	=	73.5 mm
- Straightedge	=	- 48.2 mm
Calculated size m	=	25.3 mm

x = k + l/2 - m

= 26.9 + 3.6/2 - 25.3 = 3.4 mm

Determine size of shims according to table: