Overview of components to adjust reverse gear brake -B1-

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2007 Volkswagen Golf, 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, and 2004 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Reverse Gear Brake Adjustment Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Transmission housing

With input gear and planet carrier installed

2 - Shim

3 - Outer plate -B1-

Quantity. Refer to Code letters, application, ratios, equipment

4 - Inner plate -B1-

Quantity. Refer to Code letters, application, ratios, equipment

5 - Pressure plate

Install with flat side facing plates
Spare part is determined according to transmission code letters

6 - Dished washer

Convex side faces freewheel

7 - Freewheel with -B1- piston

NOTE: Before removing or installing the freewheel, remove the valve body and take out the sealing plugs. Refer to Valve body, removing and installing . Also, remove Transmission vehicle speed sensor -G38-. Refer to Removing and installing Transmission vehicle speed sensor -G38- .

8 - Circlip