Determining shim(s): Notes

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2007 Volkswagen Golf, 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, and 2004 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

The thickness of the shim(s) is determined by gap x. Use the following formula:

Fig 1: Measuring Points To Determine Shim

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Gap x = a - b - 2.65 mm

The measuring points are shown in the illustration to help understanding the formula. Special tool 3459, which exerts a force -F- onto the plate packet via the retaining ring, is not illustrated.

Determining dimension -a-. Refer to Calculating dimension "a" .

Determining dimension -b-. Refer to Calculating dimension "b" .

2.65 mm = amount for settling is taken into account by force F.

1 - ATF pump

2 - Retaining ring

3 - Plates for -B2- without last outer plate

4 - Supporting tube

NOTE: First outer plate (arrow) and last outer plate (do not install to measure!) are always 3 mm thick.