Hydraulic Components, Assembly Overview: Notes

1 - Brake fluid reservoir 

2 - Supply hose 

3 - Clutch master cylinder 

• Removing and installing. Refer to Clutch master cylinder, removing and installing 

4 - Bearing bracket 

• Only replace with clutch master cylinder removed
• Remove. See Figure
• Install. See Figure

5 - Clutch pedal 

• Removing and installing. Refer to Clutch pedal, removing and installing 

6 - Hex nut, self-locking, 25 Nm 

• Always replace

7 - Oil seal 

• Always replace
• Pull onto line/hose connection
• Moisten with brake fluid before installing

8 - Line/hose assembly 

• Check Parts catalog for application

9 - Bracket 

• Secured to body

10 - Oil Seal 

• Always replace

11 - Bleeder 

12 - Oil Seal 

• Always replace
• Pull onto line/hose connection
• Moisten with brake fluid before installing

13 - Clip 

• To remove and install line/hose assembly, pull out clip onto stop

14 - Bleeder valve 

• Bleeding clutch system: Refer to Clutch system, bleeding 

15 - Protective cap 

16 - Clip 

• To remove and install line/hose assembly, pull out clip onto stop

17 - Slave cylinder 

• Removing and installing. Refer to Transmission, removing and installing 

18 - Clip 

• To remove and install line/hose assembly, pull out clip onto stop