Engine code BBW
WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2009 Volkswagen Golf, 2008 Volkswagen Golf, 2007 Volkswagen Golf, 2006 Volkswagen Golf, and 2005 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
1 - Camshaft sprocket
- With camshaft timing adjustment
- Under no circumstances should bolts be loosened.
- Replace complete
2 - Seal
- Replacing. Refer to Camshaft oil seal, replacing
- To remove and install, remove bearing cap
- Do not oil sealing lips of sealing ring.
- Removing and installing toothed belt from camshaft sprocket. Refer to Engine code BBW
3 - 20 Nm
4 - Bearing cap
- Installation position. See Figure .
- Installation sequence. Refer to Engine code BBW , removing and installing camshaft
- Coat contact surfaces of bearing cap 1 lightly with sealing compound AMV 174 004 01.
5 - Camshaft
- With sender wheel for camshaft position sensor
- Checking axial clearance. See Figure .
- Removing and installing. Refer to Engine code BBW
- Check radial clearance with Plastigage, Wear limit: 0.1 mm
- Run-out: max. 0.05 mm
6 - Hydraulic lifter
- Do not interchange
- With hydraulic valve clearance compensation
- Checking. Refer to Hydraulic lifters, checking
- Store with cam contact surface downward
- Before installing check camshaft axial clearance. See Figure .
- Oil contact surface
7 - Keepers
8 - Valve spring upper plate
9 - Valve spring
- Removing and installing, Cylinder head removed: with 2037; Cylinder head installed: Refer to Valve stem seals, replacing , Replacing valve stem seals
10 - Valve stem seal
- Replace. Refer to Valve stem seals, replacing
11 - Valve guide
- Checking. Refer to Valve guides, checking
- Replace. Refer to Valve guides, replacing
- Repair version with shoulder
12 - Cylinder head
- Reworking sealing surface. Refer to Figure Fig. 1
- Reworking valve seats. Refer to Valve seats, reworking
13 - Valves
- Do not rework, only lapping is permitted
- Valve dimensions. Refer to Valve seats, reworking , Fig. 4
14 - Filter element
- Pull off with hooks
- Clean if soiled
15 - Sealing plug, 12 Nm
- Always replace
16 - 130 Nm
- To loosen and tighten use counter-bracket T10172 with pin T10172/3.
17 - O-ring
- Always replace
18 - Sealing plug, 25 Nm