Engine and transmission mountings, aligning

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2009 Volkswagen Golf, 2008 Volkswagen Golf, 2007 Volkswagen Golf, 2006 Volkswagen Golf, and 2005 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and equipment

Fig 1: Identifying Support Assembly 10-222 A With Legs 10-222 A/1

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Support assembly 10-222 A with legs 10-222 A/1

CAUTION:

Before loosening bolts secure assembly using support device 10-222A.

Fig 2: Measuring Engine Mounting

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Engine mounting

-a- = 14.0 mm

-b- = at least 10.0 mm

Both bolt heads -1- must be in flush with edge -c-

Fig 3: Measuring Transmission Mounting

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Transmission mounting

Edges -a- and -b- must be parallel with one another

-c- = 18 to 20 mm

NOTE: Tightening torques for assembly mounting. Refer to Assembly mounting .