Assembly: Locking Collar/Synchronizer Hub for 1st and 2nd Gears together with Locking Pieces that are not Hollow
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Assembling Locking Collar/Synchronizer Hub Of 1st And 2nd Gear In Conjunction With Locking Pieces That Are Not Hollow
- The locking collar is pushed over the synchronizer hub.
-- Install the locking pieces and springs offset by 120°. The angled end of the spring must be positioned in front of the locking pieces -arrows-.