LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2002 >> GTI Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 202 (Gears, Shafts - Manual Transmission 0A4 (Sedan) (A5 Platform)) >> 35 Gears, Shafts >> Description And Operation >> Input Shaft, Adjusting >> Checking Measurement

Checking Measurement

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

-- Install the measuring device and the dial gauge.

Fig 1: Identifying Special Tools VW387, VW353 & VW385-17
GWWV35-1126Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Turn the input shaft so that the tapered roller bearings settle.

-- Press the input shaft in the -direction of the arrow-.

-- Bearing play should be between 0.01 and 0.09 mm.

NOTE:

The adjustment is OK if it is not possible to measure the bearing play and yet the input shaft still have a noticeable play and it easy to turn.

scientia non olet · About LEMON Manuals