Engine Speed Sensor -G28-

WARNING: This page is about a different car, the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2009 Volkswagen GLI, 2008 Volkswagen Jetta, and 2008 Volkswagen GLI. However, it is still accessible from the selected car via links, so may be relevant.

Removing

-- Remove the engine cover. Refer to ENGINE COVER .

-- Open the charge air pipe hose clamp -2-.

Fig 1: Identifying Air Guide Hose Bolts, Air Guide Pipe Hose Clamps & Electrical Harness Connector

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the electrical connector -arrow-.

-- Remove the noise insulation. Refer to Description and Operation .

-- Remove the bolts -1 and 4- and remove the charge air pipe downward from the throttle valve control module -J338-.

-- Reposition the clamp -1- and remove the charge air pipe hose downward from the charge air cooler.

Fig 2: Identifying Charge Air Hose And Clamps

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the electrical connector -1- from the engine speed sensor.

Fig 3: Identifying Engine Speed (RPM) Sensor G28 Connector -1-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the engine speed sensor bolt.

Installing

Installation is carried out in the reverse order while noting the following:

Tightening specifications, refer to IGNITION SYSTEM COMPONENT OVERVIEW .