Adjusting 5TH Gear

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Adjustment Of 5Th Gear

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Engage the 5th gear. Loosen the bolt -1-. Push the locking collar and the shift jaw in the -direction of arrow-. Tighten the bolt -1- to 25 Nm.

Check measurement: it must not be possible to slide a 0.2 mm feeler gauge between the locking collar and drive gear. Repeat the adjusting procedure if necessary.

-- Remove the 5th gear. The locking collar must be in the neutral position. The synchronizer ring must move freely.

-- Move the shift lever (selector lever) through all the gears.

-- Install the transmission housing cover. Refer to TRANSMISSION HOUSING AND 5TH GEAR COVER .

-- Install the guide sleeve for the release bearing. Refer to CLUTCH RELEASE MECHANISM OVERVIEW .

-- Install the clutch release lever and release bearing. Refer to CLUTCH RELEASE MECHANISM OVERVIEW .

-- Fill the transmission fluid. Refer to PAY ATTENTION TO THE FOLLOWING LIST FOR THE SUBJECT - "TRANSMISSION FLUID, CHECKING AND FILLING" .