Overview plan of EVAP canister system (vehicles with engine code AFP)
WARNING: This page is about a different variant/trim than selected.
1 - Tank lid unit
- with rubber cap
2 - Fuel tank
3 - Fuel Pump (FP) unit
- Removing and installing. Refer to Fuel Pump (FP) unit, removing and installing
4 - Upper section of intake manifold
5 - Fuel pressure regulator
- checking. Refer to Fuel pressure regulator and residual pressure, checking
6 - Fuel rail with fuel injectors
7 - Fuel filter
- Installation position: Arrow points in direction of flow
8 - Evaporative Emission (EVAP) Canister Purge Regulator Valve -N80-*
- Installation position: Arrow points in direction of flow
- checking. Refer to Evaporative Emission (EVAP) canister purge regulator valve 1, checking
9 - Test connection
10 - Gravity valve
11 - Pressure retention valve
12 - Change-over valve
13 - EVAP canister
- Under wheel housing liner in rear right wheel housing
14 - Leak Detection Pump (LDP) -V144-*
- Under wheel housing liner in rear right wheel housing
- checking. Refer to Leak Detection Pump (LDP), checking
15 - Air filter for diagnostic pump