Test sequence

WARNING: This page is about a different variant/trim than selected.

Remove rear muffler (Refer to Muffler with mounts (vehicles with engine codes BJS) , item 9)
Unscrew rear muffler heat shield from vehicle floor.
Remove cover beneath EVAP canister (Refer to Parts of EVAP canister system (vehicles with engine code BJS), removing and installing , item 11)

Fig 1: EVAP Canister Studs & Connector

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect 2-pin connector -1- from Evaporative Emission (EVAP) Canister Purge Solenoid Valve -N115-.