Toothed belt, tensioning
WARNING: This page is about a different variant/trim than selected.
- Tension toothed belt. To do this, remove pin T40011 and remove tensioning bolt T10092.
- Turn over crankshaft twice and check if markings on camshaft and crankshaft still align with their reference points.
- Install vibration damper and belt pulley tightening torque: 25 Nm
- Install center part of toothed belt (insert bolts with Locking Compound D 000 600 A2.) (Part numbers are for reference only. Always check with your Parts Department for the latest part number information). Torque specification: 10 Nm
- Install toothed belt cover - upper part.
- Install engine mount. Torque specifications:, refer to Assembly mounting .
- Install tensioner for ribbed belt. Torque specification: 25 Nm
- Install ribbed belt, refer to Ribbed belt, removing and installing .