Ribbed belt, removing and installing

WARNING: This page is about a different variant/trim than selected.

Special tools, testers and auxiliary items required

Fig 1: Locking Pin T10060A

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing

Fig 2: Relieving Tension On Poly V-Belt

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Swing tensioner in direction of - arrow - with an open-end wrench until it can be locked.

Fig 3: Securing Tensioner Using Locking Pin T10060 A

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Secure tensioner using Locking Pin T10060 A - arrow -.
Remove sound insulation tray, refer to NOISE INSULATION (GASOLINE ENGINES), ASSEMBLY OVERVIEW or NOISE INSULATION (DIESEL ENGINES), ASSEMBLY OVERVIEW .
Remove ribbed belt.

Installing

NOTE:

Ensure, before installing ribbed belt, that all ancillaries (generator, air conditioner compressor, power steering pump) are secured tightly.
Note previously marked direction of belt rotation and be sure that it is seated correctly on pulley.
In vehicles without A/C system, lay ribbed belt last on the generator.
In vehicles with A/C system, lay ribbed belt last on the A/C compressor.

After completing repairs always:

Ribbed belt routing

Fig 4: Identifying Belt Drive For Vehicles Without Air Conditioning

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Belt drive without air conditioning compressor

Fig 5: Identifying Belt Drive For Vehicles With Air Conditioning

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Belt drive with air conditioning compressor

NOTE: