Coolant pump, removing and installing: Installing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Volkswagen GTI, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, 2003 Volkswagen Jetta, and 2003 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse sequence; note the following points:

Moisten new O-ring with coolant.
Insert coolant pump into cylinder block and tighten securing bolts to 20 Nm.
Fit pulley and tighten securing bolts to 20 Nm.
Align engine assembly mountings → Aligning engine and transmission mountings , Aligning engine and transmission mountings.

NOTE:

Torque settings for assembly mountings → Assembly mounting .

Install ribbed belt → Ribbed belt, removing and installing under Ribbed belt, removing and installing .
Fill with coolant → Cooling system, draining and filling .