Leak Detection Pump (LDP) and EVAP canister (vehicles with engine code BJS), removing and installing: Notes

WARNING: This page is about a different variant/trim than selected.

Leak Detection Pump (LDP) -V144- is installed in right rear wheel housing. It is connected with its ventilation lines on Evaporative Emission (EVAP) Canister Purge Regulator Valve -N80- in engine compartment, right side, and on EVAP canister.

EVAP canister is installed from below on the vehicle floor in the vicinity of the spare wheel well.

Removing and installing Leak Detection Pump (LDP) -V144-. Refer to Leak Detection Pump (LDP) -V144-, removing and installing .

Removing and installing EVAP canister. Refer to EVAP canister, removing and installing .

Recommended special tools and equipment

Fig 1: Special Tool - Torque Wrench V.A.G 1331

Courtesy of VOLKSWAGEN UNITED STATES, INC.

V.A.G 1331 torque wrench (5 to 50 Nm)