EVAP canister, removing and installing
WARNING: This page is about a different variant/trim than selected.
- Remove rear muffler (Refer to Muffler with mounts (vehicles with engine codes BJS) , item 9).
- Unscrew rear muffler heat shield from vehicle floor.
- Now unscrew the right and left stabilizer bearing from vehicle floor.
- Remove cover beneath EVAP canister (Refer to Parts of EVAP canister system (vehicles with engine code BJS), removing and installing , item 11).
- Disconnect 2-pin connector -1- from Evaporative Emission (EVAP) Canister Purge Solenoid Valve -N115-.
- Unscrew studs -arrows- and remove EVAP canister.
- Installation of EVAP canister is the same in reverse order.
While installing, make sure that ventilation lines are connected securely and are not kinked.