Checking resistance
WARNING: This page is about a different variant/trim than selected.
- Check resistance between terminals of solenoid valve.
Specified value: 23.0 to 26.0 Ω
If specified value is not obtained:
- Replace Evaporative Emission (EVAP) Canister Purge Solenoid Valve -N115-. Refer to Parts of EVAP canister system (vehicles with engine code BJS), removing and installing , item 7
- Erase DTC memory of Engine Control Module (ECM). Refer to Diagnostic mode 4: Reset/erase diagnostic data
- Generate readiness code. Refer to Readiness code, generating
If specified value is obtained:
- Check wires to control module according to wiring diagram. Refer to Check wires to control module .