ATF level, checking

WARNING: This page is about a different variant/trim than selected.

Conditions for performing check

Transmission not emergency running, ATF temperature not above approx. 30 ° C
Vehicle level
Selector lever at "P"

Remove sound insulation tray.
Remove sound insulation from left longitudinal member.

Fig 1: Reservoir Of ATF Filling System V.A.G 1924 Secured To Vehicle

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Secure reservoir of ATF filling system V.A.G 1924 to vehicle.
If using tester VAS 5051, connect diagnosis cable VAS 5051/1 or VAS 5051/3 with ignition switched off to Data Link Connector (DLC).

Fig 2: VAS 5051 Connected To Data Link Connector

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Connect diagnostic cable connector to Data Link Connector (DLC).

Fig 3: Special Tool - VAS 5051 & On Switch

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Switch on tester (arrow).

NOTE: The tester requires approx. 3 minutes to warm up.

Start engine.
Select zone "Vehicle self-diagnosis" on touch screen.
From this point, tester VAS 5051 guides user further.

If V.A.G 1551 is used:

Fig 4: VAG 1551 Scan Tool With VAG 1551/3 Connected To Data Link Connector

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove diagnostic connection cover -1-.
With ignition switched off, connect V.A.G 1551 with diagnosis cable V.A.G 1551/3A.

Indicated on display

V.A.G - ON BOARD DIAGNOSTIC HELP
1 - Rapid data transfer1)
2 - Blink code output1)

1) appears alternately

Start engine.
Press key 1 for "Rapid data transfer" mode.

Indicated on display

Rapid data transfer HELP
Enter address word XX

Press keys 0 and 2. (Enters address word "transmission electronics").

Indicated on display

Rapid data transfer Q
02 transmission electronics

Confirm entry with key Q.

Indicated on display

Rapid data transfer HELP
Select function XX

Press keys 0 and 8. (Function "Read measured value block" is selected).

Indicated on display

Rapid data transfer Q
08 - Read measured value block

Confirm entry with key Q.

Indicated on display

Read measured value block
Enter display group number XXX

Press keys 0 0 5. (Selects "Display group number 005").
Confirm entry with key Q.

Indicated on display

Read measured value block 5 →
30 ° C 0011011 0 900 rpm

The first display zone shows the ATF temperature.

Bring ATF to test temperature.

Test temperature: 35 ° C to 45 ° C

Raise vehicle.
Place container under transmission.

Fig 5: ATF Level Plug

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove ATF level plug from oil pan.

Fig 6: Identifying Seal, Overflow Pipe, Sealing Plug & Cap

Courtesy of VOLKSWAGEN UNITED STATES, INC.

ATF present in overflow pipe (arrow -2-) runs out.

Observe amount of ATF draining from plug hole afterward.

If ATF drips out of the hole:

ATF need not be topped up.

Install new seal (arrow -1-) to plug and tighten to 15 Nm. ATF check is completed.

NOTE: Sealing plug (arrow -3-) and cap (arrow -4-) remain closed.

If only the ATF present in the overflow pipe runs out of the plug hole but no further draining is observed:

Top up ATF in transmission. Refer to ATF level, topping up