ATF level, topping up
WARNING: This page is about a different variant/trim than selected.
- Pry off plug securing cap (arrow) with a screwdriver. Cap locking device will be damaged, therefore always replace cap.
- Remove plug from filler pipe.
- Fill with ATF using V.A.G 1924, until ATF runs out of level hole (arrow).
NOTE:
An insufficient ATF filling as well as filling to excess affects the function of the transmission.
- Install new seal to level plug (arrow -1-) and tighten to 15 Nm.
- Install plug on filler pipe and secure with a new cap (arrow -2-).
- Lock cap.
NOTE:
Always replace cap. The cap secures the sealing plug.