Work procedure
WARNING: This page is about a different variant/trim than selected.
- Connect the scan tool.
- Start the engine and run at idle.
NOTE:
- If the engine does not start, crank the engine using starter for at least 5 seconds, do not switch the ignition off afterward under any circumstances.
- Select "Mode 6: Check test the results of components that are not continuously monitored".
- Select the desired "Test-ID" of the component or system that is to be monitored, e.g. "Test-ID 01: Oxygen Sensor Monitor Bank 1 - Sensor 1".
- Select the desired "Test-ID".
The current minimum and maximum values will be displayed on the scan tool screen.
The following table is a numerical list of all "Test-IDs" or "Hex-IDs" that may be selected.
| Test-ID (Hex-ID) | Component or System |
| 01 ($01): Test-ID 01 ($01): Catalytic Conversion (Bank 1) | Catalytic Conversion (Bank 1) |
| 02 ($02): Test-ID 02 ($02): Oxygen Sensor Bank 1- Sensor 1 | Oxygen Sensor (Bank 1- Sensor 1) |
| 05 ($05): Test-ID 05 ($05): Tank Ventilation System, Tank Leak Test | Tank Ventilation System, Tank Leak Test |