Test-ID 05 ($05): Tank Ventilation System, Tank Leak Test
WARNING: This page is about a different variant/trim than selected.
- Connect the scan tool.
- Start the engine and run at idle.
- Select "Mode 6".
Select "Test-ID 05 ($05)".
- Select the desired "Test-ID (TID)" or "Hex-ID".
- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min. | Max. | Additional Information |
| 0D ($13) | P0455 | Fuel Tank Leak Test. For additional information, refer to the Bosch Motronic M 5.9.2 OBD System Strategy. Page 13. | --- | 0.96 Sec | Refer to DTC P0455 in the OBD DTC Summary Table for all monitoring values. ADDITIONAL EXHAUST REGULATION . |
| 0D ($13) | P0442 | Pressure Check. For additional information, refer to the Bosch Motronic M 5.9.2 OBD System Strategy. Page 13. | --- | 5.8 Sec (Smallest Leak) 1.60 Sec (Small Leak) | Refer to DTC P0442 in the OBD DTC Summary Table for all monitoring values. ADDITIONAL EXHAUST REGULATION . |
- If any of components or systems fail to meet the specified values. Refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTCs or the corresponding diagnostic repair procedure → Mode 03: Interrogating fault memory .
- Switch the ignition off.
End of diagnosis