Display group 3 (Basic functions) Mass Air Flow (MAF) sensor
WARNING: This page is about a different variant/trim than selected.
| Display group 3 (Basic functions) Mass Air Flow (MAF) sensor | ||||||
|
||||||
| Read Measuring Value Block 3 | → | Indicated on display | ||||
| xxxx RPM | x.xx ms | x.x% | xx.x ° BTDC | |||
| 1 | 2 | 3 | 4 | Display zones | Specification | Evaluation |
| Ignition angle Engine code AWW Engine code AWP | 6 to 12 [degrees] BTDC 5 to 12 [degrees] BTDC | --- | ||||
| Throttle valve angle potentiometer 1 G187 | 0.2 to 4.0% | Evaluating display group 10, display zone 2 - Engine load | ||||
| Air mass drawn in | 2.0 to 4.5 g/s | Evaluating display group 2, display zone 4 - Air mass drawn in | ||||
| Engine speed (idling speed): Manual transmission Automatic transmission | 700 to 820 RPM 640 to 760 RPM | Evaluating display group 1, display zone 1 - Engine speed (idling speed) | ||||
NOTE:
- For display zone 3:
- Display values must be approx. 100% when accelerator pedal is fully depressed.