Installation notes:

Installation is in reverse order of removal. Note the following:

• Check clutch release bearing for wear and replace if necessary.
• Lightly grease clutch release bearing, guide sleeve for release bearing and input shaft splines with G 000 100.
• Check whether alignment sleeves for centralizing engine/transmission are in cylinder block, install if necessary.
• When installing the assembly, ensure clearance to the drive axle.

• Align engine and transmission mountings. Refer to Engine and transmission mounts, aligning  .
• Install drive axles: Refer to 40 FRONT SUSPENSION
• Install front exhaust pipe. Refer to Exhaust system components, removing and installing  , Exhaust system components, removing and installing.
• On vehicles with all-wheel drive, install the front drive shaft tube: Refer to 39 FINAL DRIVE, DIFFERENTIAL for 01M transmissions, or 39 - FINAL DRIVE, DIFFERENTIAL for 09A transmissions

• Install slave cylinder for hydraulic clutch: Refer to 30 CLUTCH
• Attach shift mechanism and, if necessary, adjust selector lever cable: Refer to 34 MANUAL TRANSMISSION - CONTROLS, HOUSING
• In vehicles with automatic transmission, install selector lever cable to transmission and, if necessary, adjust: Refer to 37 AUTOMATIC TRANSMISSION - CONTROLS, HOUSING for 01M Transmissions, or 37 - AUTOMATIC TRANSMISSION - CONTROLS, HOUSING for 09A transmissions
• Install power steering pump: Refer to 48 STEERING

• For vehicles with turbocharger. Clamp connecting pipe between charge air cooler and exhaust pipe at exhaust pipe.
• Electrical connections and routing: Refer to 97 WIRING
• If equipped, install air conditioning compressor: Refer to 87 - AIR CONDITIONING
• Install ribbed belt. Refer to Ribbed belt, removing and installing  .

• Install center noise insulation pan, along with left and right sides: Refer to 50 BODY, FRONT
• Fill with coolant. Refer to Cooling system, draining and filling  .