Engine and transmission mounts, aligning

WARNING: This page is about a different variant/trim than selected.

CAUTION: Before loosening bolts, secure assembly using engine support bridge 10-222A.

Engine mount assembly

a = 14.0 mm

b = minimum 10.0 mm

Fig 1: Identifying Transmission Mount Bolts & Measurements

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Both bolt heads - 1 - must be flush with edge - c -.

Transmission mount assembly

Fig 2: Identifying Engine & Transmission Mounts Alignment Edges

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Edges - a - and - b - must be parallel to each other.