Pedal cluster, assembly overview
WARNING: This page is about a different variant/trim than selected.
1 - Bulkhead
- With mounting for mounting bracket and master cylinder
2 - Seal
- Always replace
3 - Mounting bracket
- For mounting clutch pedal
4 - Bolt
5 - Mounting bracket
- For mounting accelerator pedal and brake pedal
6 - Self-locking hex nut, 25 Nm
- Always replace
7 - Connecting plate
8 - Self-locking hex nut, 25 Nm
- Always replace
9 - Mounting bushing
10 - Fulcrum pin
11 - Clutch pedal
- Removing and installing. Refer to Clutch pedal, removing and installing
12 - Retainer
- Removing and installing. Refer to item 4 in Hydraulic system, assembly overview
13 - Self-locking hex nut, 25 Nm
- Always replace
14 - Master cylinder
- Removing and installing. Refer to Master cylinder, removing and installing
15 - Supply hose
16 - Over-center spring
- Removing and installing. Refer to Over-center spring, removing and installing
17 - Over-center spring mounting
- Install in mounting bracket
- Removing and installing, to replace master cylinder. Refer to Master cylinder, removing and installing
18 - Stop
- For clutch pedal
- Installation position. Refer to Installing
19 - Self-locking hex nut, 25 Nm
- Always replace