Master cylinder, removing and installing: Installing

Installation is performed in the reverse sequence. Note the following:

Fig 1: Identifying Retainer & Clutch Master Cylinder Operating Rod

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Fit retainer -A- to master cylinder operating rod -B-.
• Press clutch pedal in direction of arrow to engage. Ensure correct location.

Fig 2: Installing Stop For Clutch Pedal Again

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Fit stop -A- for clutch pedal again.

Installation position:

The arm (arrow) points toward master cylinder -B-.

Bleeding clutch system after installing master cylinder. Refer to Clutch system, bleeding  .