Turbocharger with attachments: Notes

WARNING: This page is about a different variant/trim than selected.

Observe safety precautions. Refer to Safety precautions .

Observe rules for cleanliness. Refer to Rules for cleanliness .

NOTE:

Fig 1: Spring-Type Clip Pliers VAS 5024A

Courtesy of VOLKSWAGEN UNITED STATES, INC.

The spring-type clip pliers VAS 5024A are recommended for installing spring-type clips.
Do not install hose connections with lubricants containing oil.
Charge air system must be properly sealed.
Before screwing on oil supply line, fill turbocharger with engine oil at filler tube.

After installing turbocharger, let engine run at idle for approx. 1 minute and without increasing engine speed. This ensures that charger is lubricated.
Replace self-locking nuts.