Rules for cleanliness

When working on a turbocharger, carefully observe the following rules:

• Thoroughly clean all connections and the surrounding area before disconnecting.
• Place parts that have been removed on a clean surface and cover them. Do not use fluffy cloths!
• Carefully cover over opened components or seal, if repairs are not performed immediately.
• Only install clean components: Only unpack replacement parts immediately prior to installation. Do not use parts that have been stored loose (e.g. in tool boxes etc.).
• Supplied transport and protective packaging and sealing caps should only be removed immediately before installing.
• During repair, clean oil from connections and hose ends.
• When the system is open: Avoid working with compressed air if possible. Do not move vehicle unless absolutely necessary.