Rear seat belts, removing and installing: Notes
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 1999 Volkswagen Jetta, 1999 Volkswagen Golf, 1999 Volkswagen GTI, 1998 Volkswagen Jetta, and 1998 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The following list refers to Fig 1
.
- - Belt height adjustment fitting
- - Belt reel
- Removing and installing, refer to Removing and installing belt reel .
- - Clasp (2-door)
- Secured to side trim panel with three spring nuts
- - Rear belt anchor
- Tightening torque (hex bolt): 40 N.m (30 ft lb)
- - Lap belt
- Removing and installing, refer to Removing and installing lap belt and double latch .
- Tightening torque (hex bolt): 40 N.m (30 ft lb)
- - Double latch
- Removing and installing, refer to Removing and installing lap belt and double latch .
- Tightening torque (hex bolt): 40 N.m (30 ft lb)