Zero position:

Vehicles up to calendar week 31 1998 (CW 31/98) 

Fig 1: Identifying Square Holes In Tilt Levers Aligned With Grooves In Guide Rails

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Square holes in tilt levers must align with grooves in guide rails - arrow  -.

Vehicles from calendar week 32 1998 (CW 32/98) on 

Fig 2: Identifying Guide Rail Pin Aligned With Marking On Guide Rail

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Guide rail pin must align with marking (pin) on guide rail - arrow  -.

If this is not case, adjust parallel movement. Refer to Parallel movement, adjusting  .

• Insert sunroof panel from above and screw in securing bolts (guide rail/panel).

Fig 3: Identifying Sunroof Securing Bolts & Center Bolt

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Slightly tighten securing bolts - 1  - and - 2  - (Torx T25).
• Adjusting glass panel for sunroof (height adjustment). Refer to Glass panel for sunroof (height adjustment), adjusting 

Vehicles up to calendar week 35 2002 (CW 35/02) 

• Install lower trim and upper trim after panel height adjustment.

Vehicles from calendar week 36 2002 (CW 36/02) on 

In vehicles from calendar week 36 2002 (CW 36/02) on, a trim piece is installed in place of a lower trim and an upper trim.