Parallel movement, adjusting

WARNING: This page is about a different variant/trim than selected.

NOTE:

Parallel movement adjustment can only be performed with drive motor removed and glass panel (in zero position).

Vehicles up to calendar week 31 1998 (CW 31/98)

Fig 1: Identifying Square Holes In Tilt Levers Aligned With Grooves In Guide Rails

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Square holes in tilt levers must align with cut-outs in guide rails - arrow -.

Vehicles from calendar week 32 1998 (CW 32/98) on

Fig 2: Identifying Guide Rail Pin Aligned With Marking On Guide Rail

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Guide rail pin must align with marking (pin) on guide rail - arrow -.