Basic setting, initiating: Notes
WARNING: This page is about a different variant/trim than selected.
Function 04 "Initiate basic setting" performs several functions with ABS Mark 60:
- Display group number 001 is required only to bleed the hydraulic system. Refer to Display group number 01: Bleeding hydraulic unit
NOTE:
The basic setting is only necessary to bleed the hydraulic unit if at least one chamber of the brake fluid reservoir has completely run dry.
- Display group number 0401) is required to shut off the longitudinal acceleration sensor -G251- in order to utilize the maximum engine performance for a test, e.g. on a rolling road test stand. Refer to Display group number 40: switching off longitudinal acceleration sensor -G251- .
- Display group number 0602) is required to perform a zero compensation for steering angle sensor -G85-. Refer to Display group number 60: zero compensation of steering angle sensor -G85- . Subsequently a test drive must be performed. Refer to Display group number 93: activation of ESP driving test .
- Display group number 0632) is required to perform a zero compensation for sensor for transverse acceleration -G200-. Refer to Display group number 63: zero compensation of Sensor for transverse acceleration -G200- . Subsequently a test drive must be performed. Refer to Display group number 93: activation of ESP driving test .
- Display group number 0662) is required to perform a zero compensation for Sender 1 for brake booster -G201-. Refer to Display group number 66: zero compensation for Sender 1 for brake booster -G201- . Subsequently a test drive must be performed. Refer to Display group number 93: activation of ESP driving test .
- Display group number 0691) is required to perform a zero compensation of longitudinal acceleration sensor -G251-. Refer to Display group number 69: zero compensation of longitudinal acceleration sensor -G251- .
- Display group number 0932) is required to perform a driving test. Refer to Display group number 93: activation of ESP driving test . It serves to check the plausibility of the signals from the steering angle sensor -G85-, Sensor for transverse acceleration -G200- Sender for Rotation Rate -G202- and sender 1 for brake booster -G201-.
When the ABS control module (w/EDL) -J104- is replaced, a zero compensation must be performed for the following components:
- Sensor for transverse acceleration -G200-.
- Steering angle sensor -G85-.
- Sender 1 for brake booster -G201-.
- Longitudinal acceleration sensor -G251-.1)
When the individual sensors or sensors are changed, a zero compensation must only be carried out for the changed component.
1) For 4MOTION vehicles only
2) For ABS/EDL/ASR/ESP and ABS/EDL/ASR/ESP 4MOTION only