Diagnostic Trouble Code (DTC), memory
WARNING: This page is about a different variant/trim than selected.
All functions which could previously be performed with V.A.G 1551 can also be performed with the new tester VAS 5051.
Indicated on display:
| Rapid data transfer HELP Select function XX |
- Press keys -0- and -2-; 02 enters the "Check DTC memory" function.
Indicated on display
| Rapid data transfer Q 02 - Check DTC memory |
- Confirm entry with Q key.
The number of stored DTCs or "No DTCs recognized" appears in the display.
| X DTCs recognized! |
- Press → key.
The stored DTCs are displayed and printed out one after the other.
- With DTC information print-out eliminate malfunctions according to DTC table, Diagnostic Trouble Code (DTC) table .
As with "No DTC recognized", the program returns to the start position after pressing the → key:
Indicated on display
| Rapid data transfer HELP Select function XX |
- End output (Function 06). Refer to Diagnostic Trouble Code (DTC) memory, erasing and ending output .
- Switch off ignition and disconnect tester at DLC.
Work sequence if a DTC has been detected:
1. Repair according to DTC table, Diagnostic Trouble Code (DTC) table
2. Check DTC memory (Function 02)
3. Erase DTC memory (Function 05)
4. End output (Function 06)
5. Perform a test drive
6. Check DTC memory again